?

Log in

No account? Create an account

Previous Entry | Next Entry

Wet

I got as far as Chemult, Oregon last night – about 60 miles north of Klamath Falls – before I had to stop because I couldn't see the road well enough through the snow storm. So I stopped and stayed in a motel there.

Over the night, it snowed 10 inches on us. I have photos of the truck covered in snow, that I'll upload later. The lady at the motel counter said that there was a series of about ten storm fronts predicted to come through, one after the other for the next week. Also, the power went out in the middle of the night, and all the heaters are electric in the motel.

I took a loooong look at the road, decided to escape while I thought I could, put the snow chains on, and braved my way down the roads past Klamath falls. About there the snow turned to a driving rain. I took the chains off, and drove down to the town of Mt. Shasta, California, where I found out that the 5 freeway into Oregon was blocked both northbound and southbound due to mudslides. Given that that was my alternate route home, I seem to have dodged the bullet there.

It snowed on me again, going past Mt. Shasta, but I just put the truck in 4WD for a bit and made it past just fine. I'm currently sitting in a gas station parking lot in Redding, California, and it has yet to stop raining on me.

It's been a really intense winter rain, so far, and tugrik tells me that I'm about to get into the more severe part of it. Given the high winds and near horizontal rain so far, this should be interesting.

More later.

Tags:

Comments

( 2 comments — Leave a comment )
yaochi
Dec. 31st, 2005 01:05 am (UTC)
Good Luck Revar

Drive Carefully and Stay Safe.

Hope you make it home without incident.
dv_girl
Dec. 31st, 2005 11:33 am (UTC)
*HUG* Good luck getting home. We almost didn't make it.
( 2 comments — Leave a comment )

Latest Month

February 2018
S M T W T F S
    123
45678910
11121314151617
18192021222324
25262728   

Comments

  • 17 Oct 2011, 19:18
    Clever! ^_^
  • 7 Oct 2011, 08:38
    Was each link made from two pieces, or was there fill material inside that you removed? I'm having trouble seeing how to print these in a makerbot-compatible way (though I could just be overlooking…
  • 5 Oct 2011, 22:40
    Nah. It'd just take a dissolvable support material and higher resolution. There are commercial 3d printers out there that can print ball bearing assemblies in one pass, fully assembled.
  • 5 Oct 2011, 18:46
    Nice! ^_^ I was going to be flabbergasted if you were actually able to print it as a unit, but I guess that would take antigravity.
  • 5 Oct 2011, 18:19
    I printed each piece individually and assembled them after some cleanup. I did print four segments at a time, though, unattached, in a 2x2 grid.
Powered by LiveJournal.com
Designed by Lilia Ahner